Siemens SINAMICS G120XA - Parameters that Can be Read with Active Know-How Protection

Number Name
p0971 Save parameters / Sav par
p0972 Drive unit reset / Drv_unit reset
p2040 Fieldbus interface monitoring time / Fieldbus t_monit
p2111 Alarm counter / Alarm counter
p3950 Service parameter / Serv par
p3981 Acknowledge drive object faults / Ackn DO faults
p3985 Master control mode selection / PcCtrl mode select
p7761 Write protection / Write protection
p8402[0...8] RTC daylight saving time setting / RTC DST
p9400 Safely remove memory card / Mem_card rem
p9484 BICO interconnections search signal source / BICO S_src srch
Table 8-4 Parameters that can be read with active know-how protection
Number Name
p0015 Macro drive unit / Macro drv unit
p0100 IEC/NEMA Standards / IEC/NEMA Standards
p0170 Number of Command Data Sets (CDS) / CDS count
p0180 Number of Drive Data Sets (DDS) / DDS count
p0300[0...n] Motor type selection / Mot type sel
p0304[0...n] Rated motor voltage / Mot U_rated
p0305[0...n] Rated motor current / Mot I_rated
p0505 Selecting the system of units / Unit sys select
p0595 Technological unit selection / Tech unit select
p0730 BI: CU signal source for terminal DO 0 / CU S_src DO 1
p0731 BI: CU signal source for terminal DO 1 / CU S_src DO 2
p0732 BI: CU signal source for terminal DO 2 / CU S_src DO 3
p0806 BI: Inhibit master control / Inhibit PcCtrl
p0870 BI: Close main contactor / Close main cont
p1080[0...n] Minimum velocity / v_min
p1082[0...n] Maximum velocity / v_max
p1520[0...n] CO: Torque limit upper / M_max upper
p2000 Reference speed reference frequency / n_ref f_ref
p2001 Reference voltage / Reference voltage
p2002 Reference current / I_ref
p2003 Reference torque / M_ref
p2006 Reference temperature / Ref temp
p2030 Fieldbus interface protocol selection / Fieldbus protocol
p2038 PROFIdrive STW/ZSW interface mode / PD STW/ZSW IF mode
p2079 PROFIdrive PZD telegram selection extended / PZD telegr ext
p7763 KHP OEM exception list number of indices for p7764 / KHP OEM qty p7765
p7764[0...n] KHP OEM exception list / KHP OEM excep list
Saving the settings and series commissioning
8.6 Know-how protection
SINAMICS G120XA converter
740 Operating Instructions, 03/2019, FW V1.0, A5E44751205B AB