Siemens SINAMICS G120XA - CO: Free Tec_Ctrl 1 Actual Value after Limiter; Ftec1 Act V Af Lim; CO: Free Tec_Ctrl 1 System Deviation; Ftec1 Sys Dev; Free Tec_Ctrl 1 Actual Value Inversion; Ftec1 Act V Inv; Free Tec_Ctrl 1 Differentiation Time Constant; Ftec1 D Comp T

p11171 Free tec_ctrl 1 actual value inversion / Ftec1 act v inv
Access level: 3 Calculated: - Data type: Integer16
Can be changed: T Scaling: - Dynamic index: -
Unit group: - Unit selection: - Function diagram: 7030
Min:
0
Max:
1
Factory setting:
0
Description: Sets the inversion of the actual value signal of the free technology controller 1.
Value: 0: No inversion
1: Inversion
r11172 CO: Free tec_ctrl 1 actual value after limiter / Ftec1 act v af lim
Access level: 2 Calculated: - Data type: FloatingPoint32
Can be changed: - Scaling: PERCENT Dynamic index: -
Unit group: 9_3 Unit selection: p11126 Function diagram: 7030
Min:
- [%]
Max:
- [%]
Factory setting:
- [%]
Description: Display and connector output for the actual value after the limiter of the free technology controller 1.
r11173 CO: Free tec_ctrl 1 system deviation / Ftec1 sys dev
Access level: 2 Calculated: - Data type: FloatingPoint32
Can be changed: - Scaling: PERCENT Dynamic index: -
Unit group: 9_3 Unit selection: p11126 Function diagram: 7030
Min:
- [%]
Max:
- [%]
Factory setting:
- [%]
Description: Display and connector output for the system deviation of the free technology controller 1.
p11174 Free tec_ctrl 1 differentiation time constant / Ftec1 D comp T
Access level: 2 Calculated: - Data type: FloatingPoint32
Can be changed: T, U Scaling: - Dynamic index: -
Unit group: - Unit selection: - Function diagram: 7030
Min:
0.000 [s]
Max:
60.000 [s]
Factory setting:
0.000 [s]
Description: Sets the time constant for the differentiation (D component) of the free technology controller 1.
Note
Value = 0: Differentiation is deactivated.
p11180 Free tec_ctrl 1 proportional gain / Ftec1 Kp
Access level: 2 Calculated: - Data type: FloatingPoint32
Can be changed: T, U Scaling: - Dynamic index: -
Unit group: - Unit selection: - Function diagram: 7030
Min:
0.000
Max:
1000.000
Factory setting:
1.000
Description: Sets the proportional gain (P component) of the free technology controller 1.
Note
Value = 0: The proportional gain is deactivated.
Parameters
7.3 Parameters
SINAMICS G120XA converter
696 Operating Instructions, 03/2019, FW V1.0, A5E44751205B AB