Siemens SINAMICS G120XA - KHP Memory Card Reference Serial Number; KHP Mem Ref Ser_No; KHP Password Confirmation; KHP Passw Confirm; KHP Password New; KHP Passw New

NOTICE
An ASCII table (excerpt) can be found, for example, in the chapter of parameters.
When using the commissioning software, the password should be entered using the associated dialogs.
The following rules apply when entering the password:
- password entry must start with p7766[0].
- no gaps are permissible in the password.
- entering a password is completed when writing to p7766[29] (p7766[29] = 0 for passwords less than 30 characters).
Note
KHP: Know-How Protection
When reading, p7766[0...29] = 42 dec (ASCII character = "*") is displayed.
Parameters with the "KHP_WRITE_NO_LOCK" attribute are not involved in the know-how protection.
Parameters with the "KHP_ACTIVE_READ" attribute can be read even when know-how protection is activated.
p7767[0...29] KHP password new / KHP passw new
Access level: 3 Calculated: - Data type: Unsigned16
Can be changed: T, U Scaling: - Dynamic index: -
Unit group: - Unit selection: - Function diagram: -
Min:
-
Max:
-
Factory setting:
-
Description: Sets the new password for know-how protection.
Dependency: See also: p7766, p7768
Note
KHP: Know-How Protection
When reading, p7767[0...29] = 42 dec (ASCII character = "*") is displayed.
p7768[0...29] KHP password confirmation / KHP passw confirm
Access level: 3 Calculated: - Data type: Unsigned16
Can be changed: T, U Scaling: - Dynamic index: -
Unit group: - Unit selection: - Function diagram: -
Min:
-
Max:
-
Factory setting:
-
Description: Confirms the new password for know-how protection.
Dependency: See also: p7766, p7767
Note
KHP: Know-How Protection
When reading, p7768[0...29] = 42 dec (ASCII character = "*") is displayed.
p7769[0...20] KHP memory card reference serial number / KHP mem ref ser_no
Access level: 3 Calculated: - Data type: Unsigned8
Can be changed: T Scaling: - Dynamic index: -
Unit group: - Unit selection: - Function diagram: -
Min:
-
Max:
-
Factory setting:
-
Description: Sets the reference serial number for the memory card.
Using this parameter, if a Control Unit and/or a memory card is replaced at the end customer, the OEM can again adapt
the project to the modified hardware.
Dependency: See also: p7765, p7766, p7767, p7768
Parameters
7.3 Parameters
SINAMICS G120XA converter
668 Operating Instructions, 03/2019, FW V1.0, A5E44751205B AB