Siemens SINAMICS G120XA - BI: External Alarm 3; External Alarm 3; Change Message Type Message Number; Chng Type Msg_No; Change Message Type Type; Change Type Type

p2117[0...n] BI: External alarm 3 / External alarm 3
Access level: 3 Calculated: - Data type: Unsigned32 / Binary
Can be changed: T, U Scaling: - Dynamic index: CDS, p0170
Unit group: - Unit selection: - Function diagram: 2546
Min:
-
Max:
-
Factory setting:
1
Description: Sets the signal source for external alarm 3.
Dependency: See also: A07852
Note
An external alarm is triggered with a 1/0 signal.
p2117[0...n] BI: External alarm 3 / External alarm 3
CUG120XA_USS
(PM330)
Access level: 3 Calculated: - Data type: Unsigned32 / Binary
Can be changed: T, U Scaling: - Dynamic index: CDS, p0170
Unit group: - Unit selection: - Function diagram: 2546
Min:
-
Max:
-
Factory setting:
4022.0
Description: Sets the signal source for external alarm 3.
Dependency: See also: A07852
Note
An external alarm is triggered with a 1/0 signal.
p2118[0...19] Change message type message number / Chng type msg_no
Access level: 3 Calculated: - Data type: Unsigned16
Can be changed: T, U Scaling: - Dynamic index: -
Unit group: - Unit selection: - Function diagram: 8050, 8075
Min:
0
Max:
65535
Factory setting:
0
Description: Selects faults or alarms for which the message type should be changed.
Dependency: Selects the fault or alarm selection and sets the required type of message realized under the same index.
See also: p2119
Note
Re-parameterization is also possible if a message is present. The change only becomes effective after the message
has gone.
p2119[0...19] Change message type type / Change type type
Access level: 3 Calculated: - Data type: Integer16
Can be changed: T, U Scaling: - Dynamic index: -
Unit group: - Unit selection: - Function diagram: 8050, 8075
Min:
1
Max:
3
Factory setting:
1
Description: Sets the message type for the selected fault or alarm.
Value: 1: Fault (F)
2: Alarm (A)
3: No message (N)
Dependency: Selects the fault or alarm selection and sets the required type of message realized under the same index.
See also: p2118
Parameters
7.3 Parameters
SINAMICS G120XA converter
Operating Instructions, 03/2019, FW V1.0, A5E44751205B AB 581