Siemens SINAMICS G120XA - Replacing the Current Sensor; Removing the Current Sensor

10.2.4.3 Replacing the current sensor
Precondition
The converter power supply is switched off.
Required tools
Torque wrench for the following screws:
● Hexagon 10 mm
● Hexagon 19 mm
● TX-20
● TX-25
● TX-30
Function description
Removing the current sensor
1. Remove 2 screws (TX-25) of the front cover.
7;
7;
1P
2. Remove the front cover.
Corrective maintenance
10.2 Replacing spare parts
SINAMICS G120XA converter
Operating Instructions, 03/2019, FW V1.0, A5E44751205B AB 845