Siemens SINAMICS G120XA - Directly Entering the Parameter Number and Value; Directly Select the Parameter Number; Entering the Parameter Value Directly

A.1.3 Directly entering the parameter number and value
Directly select the parameter number
The BOP‑2 offers the possibility of setting the parameter number digit by digit.
Precondition
The parameter number is flashing in the BOP-2 display.
Procedure

2.
2.
(6&
3



3
V
1. Press the OK button for longer than five seconds.
2. Change the parameter number digit-by-digit.
If you press the OK button then the BOP‑2 jumps to the next digit.
3. If you have entered all of the digits of the parameter number, press the OK button.
You have now entered the parameter number directly.
❒
Entering the parameter value directly
The BOP‑2 offers the option of setting the parameter value digit by digit.
Precondition
The parameter value flashes in the BOP-2 display.
Procedure

3


V
(6&
2.
2.

1. Press the OK button for longer than five seconds.
2. Change the parameter value digit-by-digit.
If you press the OK button then the BOP‑2 jumps to the next digit.
3. If you have entered all of the digits of the parameter value, press the OK button.
You have now entered the parameter value directly.
❒
Appendix
A.1 Handling the BOP-2 operator panel
SINAMICS G120XA converter
880 Operating Instructions, 03/2019, FW V1.0, A5E44751205B AB