Siemens SINAMICS G120XA - Simplified Representation of the Technology Controller

/LPLWDWLRQ
6FDOLQJ
,QYHUVLRQ
)XQFWLRQI[
2XWSXW
VLJQDO
6WDUWLQJYDOXH
5HVSRQVHWR
HUURUV
$FWXDOYDOXH
2XWSXWVLJQDOZLWK
HUURU
2SHUDWLRQLVHQDEOHG
WKHPRWRULVVZLWFKHGRQ
6PRRWKLQJ
3UHSDUDWLRQ
(QDEOH
&RQWUROOHU
HQDEOH
5DPSXSUDPS
GRZQWLPH
5DPSGRZQWLPH
5DPSXSWLPH
6HWSRLQW
6HWSRLQW
6FDOLQJ
U







S
S
S
S
S
S
S
S
S
.
3
7
G
7
,

① The converter uses the start value when all the following conditions are simultaneously satisfied:
● The technology controller supplies the main setpoint (p2251 = 0).
● The ramp-function generator output of the technology controller has not yet reached the start value.
Figure 6-41 Simplified representation of the technology controller
Basic settings
The settings required as a minimum are marked in gray in the function diagram:
● Interconnect setpoint and actual values with signals of your choice
● Set ramp-function generator and controller parameters K
P
, T
I
and T
d
.
Advanced commissioning
6.5 Technology controller
SINAMICS G120XA converter
248 Operating Instructions, 03/2019, FW V1.0, A5E44751205B AB