Siemens SINAMICS G120XA - Frequently Used Connector Inputs (CI) of the Converter

Parameters
Table 6-5 Frequently used connector inputs (CI) of the converter
Parameter Description Factory setting
p1070[C] CI: Main setpoint Dependent on the converter
p1075[C] CI: Supplementary setpoint 0
p2253[C] CI: Technology controller setpoint 1 0
p2264[C] CI: Technology controller actual value 0
You can find additional connector inputs in the parameter list.
Parameters (Page 352)
Advanced commissioning
6.2 Drive control
SINAMICS G120XA converter
140 Operating Instructions, 03/2019, FW V1.0, A5E44751205B AB