Connecting converters, FSH/FSJ
To access the line and motor terminals, release the screws (four screws on FSH, and six
screws on FSJ) from the front cover, and remove the cover towards the front. See the following
example of removing the covers from converter FSH:
The diagram shows the layout of line and motor terminals, DC link terminals, and terminal strip
X9.
;
;
/LQHVXSSO\
0RWRU
/LQHVXSSO\
0RWRU
3(:
'&3
'&1
8
9:8
3(
9
3(
:
9
8
'&3
'&1
)6+)6-
:98
3(
Figure 4-10 Connections for the line supply and motor
For more information about the connection of terminal strip X9, see Chapter "Terminal strip X9
(FSH/FSJ only) (Page 97)".
Wiring
4.1 Line supply and motor
SINAMICS G120XA converter
Operating Instructions, 03/2019, FW V1.0, A5E44751205B AB 71
To Next Page
Loading...
