Siemens SINAMICS G120XA

To Next Page

To Previous Page

Description: Sets the technology application for dynamic applications (p0096 = 2).

The parameter influences the calculation of open-loop and closed-loop control parameters that is e.g. initiated using

p0340 or p3900.

Value: 0: Standard drive (e.g. pumps, fans)

1: Dynamic starting or reversing

5: Heavy-duty starting (e.g. extruders, compressors)

Dependency: The calculation of parameters dependent on the technology application can be called up as follows:

- when exiting quick commissioning using p3900 > 0

- when writing p0340 = 1, 3 or 5

See also: p1610, p1750

Note

When entering p0502 and initiating the calculation, the following parameters are set:

p0502 = 0:

- p1750.0/1/7 = 1 (start and reverse in open-loop control with rugged switchover limits)

- p1610 = 50 %, p1611 = 30 % (low up to average starting torque)

p0502 = 1:

- p1750.0/1/7 = 0 (start and reverse in closed-loop speed control with shorter acceleration times)

- p1610 = 50 %, p1611 = 30 % (only effective, if the drive is switched-on with a speed setpoint of zero)

p0502 = 5:

- p1750.0/1/7 = 1 (start and reverse in open-loop control with rugged switchover limits)

- p1610 = 80 %, p1611 = 80 % (average up to higher starting torque)

p1750.6 = 1 is always set, p1574 (voltage reserve) is preassigned, depending on p0205 (power unit application).

p0502 Technological application (Dynamic Drive Control) / Techn appl DDC

CUG120XA_USS

(PM330)

Access level: 2 Calculated: - Data type: Integer16

Can be changed: C2(1), T Scaling: - Dynamic index: -

Unit group: - Unit selection: - Function diagram: -

Min:

Max:

Factory setting: