Siemens SINAMICS G120XA - Page 909

Open-loop/closed-loop control operating mode
p1300[0...n], 509, 510
Operating hours counter power unit fan
p0251[0...n], 384
Operating hours counter power unit fan inside the
converter
p0254[0...n], 385
Operating instruction, 23
Operating Instructions, 884
Operation, 128
Operator panel
BOP-2, 877
Menu, 877
Optimizing the closed-loop speed controller, 294
Optimum motor load angle
p0327[0...n], 396
Options for electrical cabinets
p3931, 658
Output frequency smoothed
r0024, 355
Output load detection delay time
p2180[0...n], 596
Output load identification current limit
p2179[0...n], 596
Output reactor, 273
Overload, 301
Overvoltage, 309
Overvoltage protection, 100
P
Page index, 178
Parabolic characteristic, 276, 285
Parameter channel, 174
IND, 178
Parameter channel"; "IND, 177
Parameter index, 177, 178
Parameter number, 177, 880
Parameter value, 880
Parameter write inhibit status
r3996[0...1], 660
Parameters
Overview, 349, 350
Partial load operation, 872
PID autotuning monitoring time
p2354, 626
PID autotuning offset
p2355, 626
PID controller, 247
Pipe filling, 216
Pipe filling enable
p29610[0...n], 716
Pipe filling mode
p29611[0...n], 716
Pipe filling monitoring time
p29615[0...n], 717
Pipe filling speed
p29612[0...n], 717
Pipe filling threshold
p29614[0...n], 717
Pipe filling time
p29613[0...n], 717
PM330 digital inputs simulation mode
p4095, 661
PM330 digital inputs simulation mode setpoint
p4096, 661
PM330 digital outputs status
r4047, 661
PolID circle center point
p1998[0...n], 551
PolID technique
p1980[0...n], 550
Power cable length maximum
r0231[0...1], 383
Power failure, 320
Power limit motoring
p1530[0...n], 526
Power limit regenerative
p1531[0...n], 526
Power unit application
p0205, 379
Power unit code number
p0201[0...n], 377
Power unit code number actual
r0200[0...n], 377
Power unit EEPROM characteristics
r3930[0...4], 658
Power unit hardware properties
r0204[0...n], 378
Power unit main contactor holding time after OFF1
p0867, 453
Power unit maximum current
r0209[0...4], 381
Power unit monitoring time
p0857, 452
Power unit motor reactor
p0233, 383
Power unit overload response
p0290, 385
Power unit sine-wave filter capacitance
p0234, 383
Power unit temperature alarm threshold
p0292[0...1], 386
Index
SINAMICS G120XA converter
Operating Instructions, 03/2019, FW V1.0, A5E44751205B AB 907