EasyManua.ls Logo

STMicroelectronics STM32WL5 Series

STMicroelectronics STM32WL5 Series
1450 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Sub-GHz radio (SUBGHZ) RM0453
184/1450 RM0453 Rev 5
Set_RfFrequency() command
Set_RfFrequency(RfFreq) is used to lock the RF-PLL frequency to the transmit and
receive frequency.
Set_TxParams() command
Set_TxParams(Power, RampTime) is used to set the transmit output power and the PA
ramp-up time.
01234
Opcode RfFreq[31:0]
wwwww
byte 0 bits 7:0 Opcode: 0x86
bytes 4:1 bits 31:0 RfFreq[31:0]: RF frequency
RF-PLL frequency = 32e
6
x RFfreq / 2
25
012
Opcode Power[7:0] RampTime[7:0]
www
byte 0 bits 7:0 Opcode: 0x8E
byte 1 bits 7:0 Power[7:0]: Output power setting
LP PA selected in Set_PaConfig()
0x0E:+ 14 dB
...
0x00: 0 dB
...
0xEF: - 17 dB
Others: reserved
HP PA selected in Set_PaConfig()
0x16:+ 22 dB
...
0x00: 0 dB
...
0xF7: - 9 dB
Others: reserved
byte 2 bits 7:0 RampTime[7:0]: PA ramp time for FSK, MSK and LoRa modulation
0x00: 10 μs
0x01: 20 μs
0x02; 40 μs
0x03: 80 μs
0x04: 200 μs
0x05: 800 μs
0x06: 1700 μs
0x07: 3400 μs
Others: reserved
Note: In BPSK mode, the ramping time is specific and RampTime[7:0] is not
used.

Table of Contents

Related product manuals