Tektronix Keithley 2601B-PULSE Reference Manual

Model 2601B-PULSE System SourceMeter Instrument Reference Manual Section 5: Reading buffers
2601B-PULSE-901-01A April 2020 5-7
Commands to store readings
smua.measure.count = count
The number of measurements to acquire.
smua.measure.overlappedi(rbuffer)
Makes current measurements; stores readings in
rbuffer.
smua.measure.overlappediv(ibuffer,
vbuffer)
Makes both current and voltage measurements; stores
current readings in ibuffer and stores voltage
readings in vbuffer.
smua.measure.overlappedp(rbuffer)
Makes power measurements; stores readings in
rbuffer.
smua.measure.overlappedr(rbuffer)
Makes resistance measurements; stores readings in
rbuffer.
smua.measure.overlappedv(rbuffer)
Makes voltage measurements; stores readings in
rbuffer.
smua.measure.v(rbuffer)
Makes voltage measurements; stores readings in
rbuffer.
smua.measure.i(rbuffer)
Makes current measurements; stores readings in
rbuffer.
smua.measure.iv(ibuffer, vbuffer)
Makes both current and voltage measurements; stores
current readings in ibuffer and stores voltage
readings in vbuffer.
smua.measure.r(rbuffer)
Makes resistance measurements; stores readings in
rbuffer.
smua.measure.p(rbuffer)
Makes power measurements; stores readings in
rbuffer.
smua.trigger.measure.v(rbuffer)
Configures voltage measurements to be made during a
sweep, including where readings are stored (rbuffer).
smua.trigger.measure.i(rbuffer)
Configures current measurements to be made during a
sweep, including where readings are stored (rbuffer).
smua.trigger.measure.r(rbuffer)
Configures resistance measurements to be made during
a sweep, including where readings are stored
(rbuffer).
smua.trigger.measure.p(rbuffer)
Configures power measurements to be made during a
sweep, including where readings are stored (rbuffer).
smua.trigger.measure.iv(ibuffer,
vbuffer)
Configures both current and voltage measurements to be
made during a sweep, including where readings are
stored; current readings are stored in ibuffer and
voltage readings are stored in vbuffer.
Commands to access readings:
printbuffer(start_index, end_index,
st_1, st_2, ... st_n)
Prints data from buffer subtables:
start_index (starting index of values to print).
end_index (ending index of values to print).
st_1, st_2, ... st_n (subtables from which to print,
each separated by a comma).

Tektronix Keithley 2601B-PULSE Specifications

General

Brand	Tektronix
Model	Keithley 2601B-PULSE
Category	Measuring Instruments
Language	English