Section 11: TSP command reference Model 2601B-PULSE System SourceMeter Instrument Reference Manual
11-80 2601B-PULSE-901-01A April 2020
eventlog.enable
This attribute enables or disables the event log.
Instrument reset
Recall setup
Usage
status = eventlog.enable
eventlog.enable = status
The enable status of the event log:
1 or eventlog.ENABLE: Event log enable
0 or eventlog.DISABLE: Event log disable
Details
When the event log is disabled (eventlog.DISABLE or 0), no new events are added to the event
log. You can, however, read and remove existing events.
When the event log is enabled, new events are logged.
Example
print(eventlog.enable)
eventlog.enable = eventlog.DISABLE
print(eventlog.enable)
Displays the present status of the
2601B-PULSE event log.
Output:
1.00000e+00
0.00000e+00
Also see
eventlog.all() (on page 11-78)
eventlog.clear() (on page 11-79)
eventlog.count (on page 11-79)
eventlog.next() (on page 11-81)
eventlog.overwritemethod (on page 11-82)