Section 9: Introduction to TSP operation Model 2601B-PULSE System SourceMeter Instrument Reference Manual
9-6 2601B-PULSE-901-01A April 2020
Digital I/O
The digital I/O port of the instrument can control external circuitry (such as a component handler for
binning operations).
The I/O port has 14 lines. Each line can be at TTL logic state 1 (high) or 0 (low). See the pinout
diagram in Digital I/O port (on page 6-36) for additional information.
There are commands to read and write to each individual bit, and commands to read and write to the
entire port.
digio.readbit() (on page 11-42)
digio.readport() (on page 11-43)
digio.trigger[N].assert() (on page 11-44)
digio.trigger[N].clear() (on page 11-44)
digio.trigger[N].EVENT_ID (on page 11-45)
digio.trigger[N].mode (on page 11-45)
digio.trigger[N].overrun (on page 11-47)
digio.trigger[N].pulsewidth (on page 11-47)
digio.trigger[N].release() (on page 11-48)
digio.trigger[N].reset() (on page 11-49)
digio.trigger[N].stimulus (on page 11-50)
digio.trigger[N].wait() (on page 11-51)
digio.writebit() (on page 11-52)
digio.writeport() (on page 11-52)
digio.writeprotect (on page 11-53)
Display
display.clear() (on page 11-54)
display.getannunciators() (on page 11-54)
display.getcursor() (on page 11-56)
display.getlastkey() (on page 11-57)
display.gettext() (on page 11-58)
display.inputvalue() (on page 11-59)
display.loadmenu.add() (on page 11-61)
display.loadmenu.catalog() (on page 11-62)
display.loadmenu.delete() (on page 11-63)
display.locallockout (on page 11-63)
display.menu() (on page 11-64)
display.numpad (on page 11-65)
display.prompt() (on page 11-65)
display.screen (on page 11-67)
display.sendkey() (on page 11-67)
display.setcursor() (on page 11-69)
display.settext() (on page 11-70)
display.smua.digits (on page 11-68)
display.smua.limit.func (on page 11-71)
display.smua.measure.func (on page 11-71)
To Next Page
Loading...
Need help?
General
