To Next Page

To Previous Page

Model 2601B-PULSE System SourceMeter Instrument Reference Manual Section 11: TSP command reference

2601B-PULSE-901-01A April 2020 11-389

tspnet.tsp.runscript()

This function loads and runs a script on a remote TSP-enabled instrument.

Type

TSP-Link accessible

Affected by

Where saved

Default value

Function

Yes

Usage

tspnet.tsp.runscript(connectionID, "script")

tspnet.tsp.runscript(connectionID, "name", "script")

connectionID

Integer value used as an identifier for other tspnet commands

name

The name that is assigned to the script

script

The body of the script as a string

Details

This function is appropriate only for TSP-enabled instruments.

This function downloads a script to a remote instrument and runs it. It automatically adds the

appropriate loadscript and endscript commands around the script, captures any errors, and

reads back any prompts. No additional substitutions are done on the text.

The script is automatically loaded, compiled, and run.

Any output from previous commands is discarded.

This command does not wait for the script to complete.

If you do not want the script to do anything immediately, make sure the script only defines functions

for later use. Use the tspnet.execute() function to execute those functions later.

If no name is specified, the script is loaded as the anonymous script.

Example

tspnet.tsp.runscript(myconnection, "mytest",

"print([[start]]) for d = 1, 10 do print([[work]]) end print([[end]])")

Load and run a script entitled mytest on the TSP-enabled instrument connected with myconnection.

Also see

tspnet.execute() (on page 11-382)

Tektronix Keithley 2601B-PULSE Reference Manual

Other manuals for Tektronix Keithley 2601B-PULSE