Model 2601B-PULSE System SourceMeter Instrument Reference Manual Section 9: Introduction to TSP operation
2601B-PULSE-901-01A April 2020 9-9
Instrument identification
These commands store strings that describe the instrument.
localnode.description (on page 11-139)
localnode.model (on page 11-140)
localnode.revision (on page 11-145)
localnode.serialno (on page 11-145)
LAN and LXI
The LAN commands have options that allow you to review and configure network settings.
The lan.config.* commands allow you to configure LAN settings over the remote interface. Note
that you must send lan.applysettings() for the configuration settings to take effect.
The lan.status.* commands help you determine the status of the LAN.
The lan.trigger[N].* commands allow you to set up and assert trigger events that are sent over
the LAN.
Other LAN commands allow you to reset the LAN, restore defaults, check LXI domain information,
and enable or disable the Nagle algorithm.
lan.applysettings() (on page 11-109)
lan.autoconnect (on page 11-110)
lan.config.dns.address[N] (on page 11-111)
lan.config.dns.domain (on page 11-112)
lan.config.dns.dynamic (on page 11-112)
lan.config.dns.hostname (on page 11-113)
lan.config.dns.verify (on page 11-114)
lan.config.duplex (on page 11-114)
lan.config.gateway (on page 11-115)
lan.config.ipaddress (on page 11-116)
lan.config.method (on page 11-116)
lan.config.speed (on page 11-117)
lan.config.subnetmask (on page 11-118)
lan.linktimeout (on page 11-118)
lan.lxidomain (on page 11-119)
lan.nagle (on page 11-120)
lan.reset() (on page 11-120)
lan.restoredefaults() (on page 11-121)
lan.status.dns.address[N] (on page 11-122)
lan.status.dns.name (on page 11-122)
lan.status.duplex (on page 11-123)
lan.status.gateway (on page 11-124)
lan.status.ipaddress (on page 11-124)
lan.status.macaddress (on page 11-125)
To Next Page
Loading...
Need help?
General
