Model 2601B-PULSE System SourceMeter Instrument Reference Manual Section 1: Introduction
2601B-PULSE-901-01A April 2020 1-3
Capabilities and features
Key features:
• Pulser output of 10 A at 10 V
• SMU outupt of 10 A at 20 V
• No tuning required; works with inductive loads up to 3 μH
• Pulser has dual 1 megasample/second digitizers for simultaneous high-speed sampling of current
and voltage
• SMU has dual integrating analog-to-digital converters for simultaneous measurement of current
and voltage
• DC capability up to ±40 V at ±1.0 A, 40 W
• TSP technology embeds complete test programs inside the instrument for best-in-class
system-level throughput
• TSP-Link expansion technology for multi-channel parallel test without a mainframe
• USB 2.0, ethernet, GPIB, RS-232, and digital I/O interfaces
• Supported in the Keithley KickStart non-programming software tool
General features:
• 4.5, 5.5, or 6.5 digit display resolution
• Resistance and power measurement functions
• Four-quadrant sink or source operation
• Linear, logarithmic, and custom sweeping
• Filtering to reduce reading noise
• Trigger model supports extensive triggering and synchronization schemes at hardware speeds
• The SMU provides contact check
• The SMU provides high-capacitance mode for load impedances up to 50 µF
• Internal memory stores five user setup options
• Dedicated reading buffers that can each store and recall over 140,000 measurements; additional
dynamic reading buffers can be created
• USB flash drive access for saving data buffers, test scripts, and user setups
• Digital I/O port: Allows the 2601B-PULSE to control other devices
• Version 1.5 LXI Device Specification 2016 compliant
To Next Page
Loading...
