Section 9: Introduction to TSP operation Model 2601B-PULSE System SourceMeter Instrument Reference Manual
9-16 2601B-PULSE-901-01A April 2020
Time
bufferVar.basetimestamp (on page 11-18)
bufferVar.collecttimestamps (on page 11-24)
bufferVar.timestampresolution (on page 11-36)
bufferVar.timestamps (on page 11-37)
delay() (on page 11-42)
gettimezone() (on page 11-97)
os.time() (on page 11-152)
settime() (on page 11-172)
settimezone() (on page 11-173)
timer.measure.t() (on page 11-349)
timer.reset() (on page 11-349)
Triggering
Triggering allows you to source signals and capture measurements when an input signal or
combination of input signals meet a set of conditions that you set. Triggering controls the timing of
when source and measure operations happen during a sweep. See Sweep operation (on page 4-61)
for details on sweeping.
digio.trigger[N].assert() (on page 11-44)
digio.trigger[N].clear() (on page 11-44)
digio.trigger[N].EVENT_ID (on page 11-45)
digio.trigger[N].mode (on page 11-45)
digio.trigger[N].overrun (on page 11-47)
digio.trigger[N].pulsewidth (on page 11-47)
digio.trigger[N].release() (on page 11-48)
digio.trigger[N].reset() (on page 11-49)
digio.trigger[N].stimulus (on page 11-50)
digio.trigger[N].wait() (on page 11-51)
display.trigger.clear() (on page 11-72)
display.trigger.EVENT_ID (on page 11-73)
display.trigger.overrun (on page 11-73)
display.trigger.wait() (on page 11-74)
lan.trigger[N].assert() (on page 11-129)
lan.trigger[N].clear() (on page 11-129)
lan.trigger[N].connect() (on page 11-130)
lan.trigger[N].connected (on page 11-131)
lan.trigger[N].disconnect() (on page 11-131)
lan.trigger[N].EVENT_ID (on page 11-132)
lan.trigger[N].ipaddress (on page 11-132)
lan.trigger[N].mode (on page 11-133)
lan.trigger[N].overrun (on page 11-134)
lan.trigger[N].protocol (on page 11-135)
lan.trigger[N].pseudostate (on page 11-135)
lan.trigger[N].stimulus (on page 11-136)
lan.trigger[N].wait() (on page 11-137)
smua.pulser.measure.delay (on page 11-215)
To Next Page
Loading...
Need help?
General
