Section 3: Instrument description Model 2601B-PULSE System SourceMeter Instrument Reference Manual
3-6 2601B-PULSE-901-01A April 2020
5. Digital I/O
Female DB-25 connector. Use a cable equipped with a male DB-25
connector (Keithley Instruments part number CA-126-1A; L-com part
number CSMN25MF-5).
Pins provided:
â–ª Fourteen digital input or output pins
â–ª Seven GND pins
â–ª Three +5 V pins
6. IEEE-488
Connector for IEEE-488 (GPIB) operation. Use a shielded cable, such as
the Keithley Instruments Model 7007-1 or Model 7007-2.
7. Cooling exhaust vents
Exhaust vent for the internal cooling fan. Keep the vent free of obstructions
to prevent overheating. Also see Cooling vents (on page 2-8).
8. LAN
RJ-45 connector for a local area network (LAN). The LAN interface
supports Auto-MDIX, so either a CAT-5e crossover cable (provided), or a
normal CAT-5e straight-through cable (not provided) can be used.
9. USB port
This USB-2.0 receptacle (Type B) located on the rear panel is used to
connect the instrument to a computer. You can use this connection to send
commands to the instrument.
10. Ground
Ground terminal for connecting output HI or LO to chassis ground.
Ground screw for connecting to chassis ground.
11. TSP-Link
Expansion interface that allows a 2601B-PULSE and other TSP-enabled
instruments to trigger and communicate with each other.
To Next Page
Loading...
Need help?
General
