Xerox Phaser 6128MFP - Out of Memory

Phaser 6128MFP Service Manual 3-115
Error Messages and Codes
Out of Memory
The printer controller has detected a memory access error. The following
troubleshooting procedure applies to these errors.
Applicable Errors
• 016-718: Out of Memory Error
• 016-720: PDL Error
Initial Actions
• Cycle printer power.
• If the problem persists, follow the procedure below.
Troubleshooting Procedure Table
Step Actions and Questions Yes No
1 Check the Image Processor Board
for correct installation.
Is the Image Processor Board
correctly installed?
Go to step 2. Reseat
connections on
the Image
Processor
Board
(page 8-41).
2 Does the error still occur when the
printer is turned On?
Replace the
Image
Processor Board
(page 8-41).
Complete.
Troubleshooting Reference Table
Applicable Parts Wiring and Plug/Jack Map References
■ Image Processor Board, PL10.6.6 ■ “Map 3 - Electrical and Drive” on page 10-8
Troubleshooting Procedure Table
Step Actions and Questions Yes No
1 Check the memory.
Print the Configuration page to
determine installed memory size.
Is the print job too large?
Divide the print
job to fit
installed
memory.
Go to step 2.