Xerox Phaser 6128MFP - Copier Error Last Sheet Not Copied

Phaser 6128MFP Service Manual 3-131
Error Messages and Codes
Copier Error Last Sheet not Copied
An error in the imaging subsystem was detected. The following troubleshooting
procedure applies to this error.
Applicable Error
• Copier Error Last Sheet not Copied
Initial Actions
• Cycle printer power.
• If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts Wiring and Plug/Jack Map References
■ Image Processor Board, PL10.6.6 ■ “Imaging” on page 10-24
Troubleshooting Procedure Table
Step Actions and Questions Yes No
1 Does the error message disappear
within 70 seconds automatically, or
disappear after pressing the OK
button?
Go to step 2. Go to step 4.
2 Does the error persist when copying,
faxing, or scanning?
Go to step 3. To to step 4.
3 Print a Configuration page: System
> Information Pages >
Configuration.
Does the error persist when copying,
faxing, or scanning?
Go to step 4. Complete.
4 Cycle system power.
Does the error persist?
Replace the
Image
Processor Board
(page 8-41).
Complete.