Xerox Phaser 6128MFP - Incorrect Password Error

3-144 Phaser 6128MFP Service Manual
Error Messages and Codes
Incorrect Password Error
The DFAX password does not match with the Fax/Scan Lock password. The
following troubleshooting procedure applies to this error.
Applicable Error
• 033-517: Incorrect Password
Initial Actions
• Cycle printer power.
• If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts Wiring and Plug/Jack Map References
■ Image Processsor Board, PL10.6.6
“Imaging” on page 10-24
Troubleshooting Procedure Table
Step Actions and Questions Yes No
1 Check the password setting.
Is the password correct?
Go to step 2. Set the
password.
2 Set the Panel Lock Set to Disable.
Does the error persist?
Replace the I/P
Board
(page 8-41).
Set the Panel
Lock Set to
Enable. If the
error returns,
replace the I/P
Board
(page 8-41).