Phaser 6128MFP Service Manual 8-3
Service Parts Disassembly
Preparation
Before you begin any servicing procedure:
Unplug the power cord from the wall outlet.
Allow the Fuser to cool before starting the procedure.
Remove and cover the Imaging Unit to avoid light exposure.
1. Wear an Electrostatic Discharge wrist strap.
2. Turn Off power and disconnect the power cord from the wall outlet.
3. Disconnect all cables from the printer.
4. Remove these items:
a. Imaging Unit (page 8-8).
b. Tray
c. Fuser (page 8-11).
d. Toner Cartridges (page 8-13).
The disassembly procedures do not include steps for the removal of the parts
listed above.
Names of parts that appear in the removal and replacement procedures may
not match the names that appear in the Parts List. For example, a part called
Paper Tray in a removal procedure may appear on the Parts List as CASSETTE,
ASSY. When working on a removal procedure, ignore any prerequisite
procedure for parts already removed.
Many parts are secured by plastic tabs. DO NOT over flex or force these parts.
DO NOT over torque the screws threaded into plastic parts.
Procedural flow diagrams are included in the Reference chapter. These diagrams
indicate the sequence ofparts removal or replacement. Use these diagrams as a
guide to which parts to remove to access a specific part, or in which order to
reassemble parts.
To Next Page
Loading...
