Xerox Phaser 6128MFP - Feed Roller

8-10 Phaser 6128MFP Service Manual
Service Parts Disassembly
Feed Roller
PL3.2.4
1. Open the Front Cover.
2. Remove the Imaging Unit (page 8-8)
3. Reach in through the opening in the bottom of the Imaging Unit cavity and
release the hook on the left side of the roller. Move the roller core to the left
side.
4. Move the Feed Roller to the left, so that the grooves in the Feed Roller are clear
of the pins on the feed shaft.
5. Rotate the Feed Roller 180° on the feed shaft and allow the Feed Roller to drop
off the shaft.
Replacement Note
Because there are grooves in only in one side of the Feed Roller, it fits over
the pins on the feed shaft in only one direction. Note the location of the
grooves when installing the Feed Roller on the shaft.
s6128mfp-181