ABB AC500 V3 - Connection of active-type analog sensors (Voltage) with galvanically isolated power supply; Connection of active-type analog sensors (Current) with galvanically isolated power supply

Connection of active-type analog sensors (Voltage) with galvanically isolated power supply
By connecting the sensor's negative pole of the output voltage to AGND, the
galvanically isolated voltage source of the sensor is referred to ZP.
By connecting to AGND the galvanically isolated voltage source of the sensor is referred to ZP.
The following measuring ranges can be configured:
Voltage 0 V...10 V 1 channel used
Voltage -10 V...+10 V 1 channel used
In order to avoid error messages or long processing times, it is useful to configure unused
analog input channels as "unused".
Connection of active-type analog sensors (Current) with galvanically isolated power supply
Device specifications
I/O modules > Analog I/O modules
2022/01/313ADR010278, 3, en_US414