4 5 6
Conductor
Screwdriver
Fig. 193: Disconnect wire from the spring terminal (steps 4 to 6)
1. Terminal with wire connected
2. Insert screwdriver (2.5 x 0.4 to 3.5 x 0.5 mm) at an angle, screwdriver must be at least 15
mm free of insulation at the tip
3. While erecting the screwdriver, insert it until the stop (requires a little strength) - terminal is
now open
4. Remove wire from the open terminal
5. Done
2.6.4.5 Terminals for CANopen/DeviceNet communication modules
Fig. 194: Combicon, 5-pole, female, removable plug with spring terminals
Fig. 195: Combicon, 5-pole, female, removable plug with spring terminals
System assembly, construction and connection
AC500 (Standard) > Connection and wiring
2022/01/313ADR010278, 3, en_US994
To Next Page
Loading...
