ABB AC500 V3 - Connection of analog output loads (Voltage, current)

1.0
1.1
1.8
1.9
AI0+
AI1+
UP
ZP
UP
ZP
PTC
1.5
AI–
1
Fig. 130: Use of analog inputs as digital inputs
1 1 digital signal requires 1 channel
Digital input 24 V 1 channel used
The measuring ranges are described in the section Measuring Ranges Ä Chapter 1.7.3.1.7
“Parameterization” on page 694 Ä Chapter 1.7.3.1.10 “Measuring ranges” on page 703.
Connection of analog output loads (Voltage, current)
The following figure shows the connection of analog output loads (voltage, current).
Device specifications
Communication interface modules (S500) > EtherCAT
2022/01/31 3ADR010278, 3, en_US 691