ABB AC500 V3 - 1.5.3.1 Technical data

XC = eXtreme Conditions
Extreme conditions
Terminal units for use in extreme ambient conditions have no sign for
XC version.
The figure 4 in the Part no. 1SAP4... (label) identifies the XC version.
Screw terminals Spring terminals
Conductor
1.5
1.6
1.7
1.8
1.9
Screwdriver Conductor
1.5
1.6
1.7
1.8
1.9
Screwdriver
(opens ter-
minal)
– For information about wiring specifications see the description of the ter-
minal units Ä Chapter 2.6.4.3 “Terminals at the terminal unit” on page 990.
– For a detailed description of the mounting, disassembly and connection of
the module, please refer to the System Assembly, Construction and Con-
nection chapter
Ä Chapter 2.6 “AC500 (Standard)” on page 971.
– For information about mechanical dimensions, please refer to the Mechan-
ical dimensions S500 chapter Ä Chapter 2.6.2.3 “Mechanical dimensions
S500” on page 979
The terminals 2.8, 3.8, 2.9, 3.9 and 4.9 are electrically interconnected within the terminal unit
and always have the same assignment, irrespective of the inserted communication interface
module:
● Terminals 2.8 and 3.8: process supply voltage UP = +24 V DC
● Terminal 4.8: process supply voltage UP3 = +24 V DC
● Terminals 2.9, 3.9 and 4.9: process supply voltage ZP = 0 V
The assignment of the other terminals depends on the inserted communication interface module
(see communication interface modules for CANopen and PROFIBUS).
1.5.3.1 Technical data
The system data of AC500 and S500 Ä Chapter 2.6.1 “System data AC500” on page 971 are
applicable to the standard version.
XC version
Terminals
Device specifications
Terminal units (AC500 standard) > TU517 and TU518 for communication interface modules
2022/01/313ADR010278, 3, en_US134