NOTICE!
Risk of corrosion!
Unused connectors and slots may corrode if XC devices are used in salt-mist
environments.
Protect unused connectors and slots with TA535 protective caps for XC
devices.
Ä
Chapter 1.8.3.4 “TA535 - Protective caps for XC devices”
on page 906
1.5.1.1 Technical data
The system data of AC500 and S500
Ä
Chapter 2.6.1 “System data AC500” on page 971 are
applicable to the standard version.
The system data of AC500-XC
Ä
Chapter 2.7.1 “System data AC500-XC” on page 1023 are
applicable to the XC version.
Only additional details are therefore documented below.
The technical data are also applicable to the XC version.
Parameter Value
Number of I/O channels per module Max. 24 (depending on the inserted communi-
cation interface module)
Distribution of the channels into groups 3 groups of max. 8 channels each (1.0...1.7,
2.0...2.7, 3.0...3.7), the allocation of the chan-
nels is given by the inserted Ethernet bus
module
Network interface connector 2 RJ45, 8-pole
Rated voltage 24 V DC
Max. permitted total current 10 A via the supply terminals (UP, UP3 and
ZP)
Ethernet 10/100 base-TX or 100 base-TX (depending
on CI5xx module plugged in), 2 RJ45 socket
Grounding Direct connection to the grounded DIN rail or
via the screws with wall mounting
Screw terminals Front terminal, conductor connection vertically
with respect to the printed circuit board
Spring-type terminals Front terminal, conductor connection vertically
with respect to the printed circuit board
Weight 200 g
Mounting position Horizontal or vertical
Terminal units (AC500 standard) > TU507-ETH and TU508-ETH for Ethernet communication interface modules
2022/01/31 3ADR010278, 3, en_US 125
To Next Page
Loading...
