1.3.1.2.4 TA5130-KNXPB - Option board KNX adress push button
1 State LED
2 Allocation of signal name
3 Connector
For more information about TA5130-KNXPB, please refer to the Automation
Builder online help.
This option board is only intended to be used with PM5072-T-2ETH(W).
This option board can only be used once on one slot at a time!
The option board is not supported by other AC500-eCo V3 PLCs.
Information can be found in the chapter system technology: see
Information can be found in the chapter system technology: see
Information about the integration of the PLC in KNX can be found here:
The arrangement of the parameter data is performed with Automation Builder software.
1. In the device tree, double-click the desired option board.
2. Select the “TA51xx Parameters” tab to edit the parameterization of the desired option
board.
Intended pur-
pose
Functionality
Parameteriza-
tion
Processor modules > AC500-eCo
2022/01/313ADR010278, 3, en_US72
To Next Page
Loading...
