1.4.4.1.4 Technical data
The system data of AC500 and S500
Ä
Chapter 2.6.1 “System data AC500” on page 971 are
applicable to the standard version.
The system data of AC500-XC
Ä
Chapter 2.7.1 “System data AC500-XC” on page 1023 are
applicable to the XC version.
Only additional details are therefore documented below.
The technical data are also applicable to the XC version.
Parameter Value
Internal Supply Via the communication module interface of the
terminal base
Protocol EtherCAT
Field bus connector 2 x RJ45 (ETHCAT1 and ETHCAT2)
Technology Hilscher NETX 100
Transfer rate 10/100 Mbit/s (full-duplex)
Transfer method According to Ethernet II, IEEE 802.3
Ethernet 100 base-TX, internal switch, 2x RJ45 socket
Bus length (segment length max.) 100 m at 100 Mbit/s
Indicators 5 LEDs
Usable CPUs
PM56xx
Ä
Chapter 1.3.2.1 “PM56xx-2ETH for
AC500 V3 products” on page 90
Usable terminal bases
All TB56xx (not TB5600)
Ä
Chapter 1.2.1
“TB56xx for AC500 V3 products” on page 4
Ambient temperature
System data AC500
Ä
Chapter 2.6.1 “System
data AC500” on page 971
System Data AC500 XC
Ä
Chapter 2.7.1
“System data AC500-XC” on page 1023
Current consumption from 24 V DC power
supply at the terminal base of the CPU
Typ. 85 mA
Internal supply Via the communication module interface of the
terminal base
Number of slaves Limited to 200
Quantity of input and output data for a single
slave
Max. 5760 bytes (respectively for input and
output)
Total quantity of input and output data Max. 5760 bytes (only valid for asynchro-
nous operation, for synchronous operation the
reachable values depends on the additional
load of SoE, CoE and EoE, typical reachable
values are 1024 bytes).
Supported protocols RTC - Real-time cyclic protocol, class 1
RTA - Real-time acyclic protocol
Acyclic services ● CoE upload
● CoE download (1500 bytes max.)
● Emergency
Min. bus cycle 1 ms
Max. size of the bus configuration file 2 MB
Weight Ca. 170 g
Communication modules (AC500 standard) > EtherCAT
2022/01/31 3ADR010278, 3, en_US 115
To Next Page
Loading...
