ABB AC500 V3 - Connection of analog output loads (Current)

Fig. 95: Connection of analog output loads (voltage)
The following measuring ranges can be configured Ä Chapter 1.6.3.1.2.6 “Parameterization”
on page 599
Ä Chapter 1.6.3.1.2.9 “Measuring ranges” on page 606:
Voltage -10 V...+10 V Load ±10 mA max. 1 channel used
For a description of the function of the LEDs, please refer to Diagnosis and displays / Displays
Ä Chapter 1.6.3.1.2.8 “State LEDs” on page 606.
Unused analog outputs can be left open-circuited.
Connection of analog output loads (Current)
The following figure shows the connection of output loads to the analog output AO0. Proceed
with the analog output AO1 in the same way.
Device specifications
I/O modules > Digital/Analog I/O modules
2022/01/31 3ADR010278, 3, en_US 597