ABB AC500 V3 - Connection of active-type analog sensors (Current) with galvanically isolated power supply; Connection of active-type analog sensors (Voltage) with no galvanically isolated power supply

Connection of active-type analog sensors (Current) with galvanically isolated power supply
Fig. 28: Connection example
The following measuring ranges can be configured Ä Chapter 1.6.2.2.2.6 “Parameterization”
on page 444 Ä Chapter 1.6.2.2.2.9 “Measuring ranges” on page 449
Current 0 mA...20 mA 1 channel used
Current 4 mA...20 mA 1 channel used
The function of the LEDs is described under Displays Ä Chapter 1.6.2.2.2.7 “Diagnosis”
on page 447.
Unused input channels can be left open-circuited, because they are of low resistance.
Connection of active-type analog sensors (Voltage) with no galvanically isolated power supply
UP
ZP
1.0
I0-
1.1
I1-
1.8
UP
1.9
ZP
PTC
2.0
I0+
2.1
I1+
2.8
UP
2.9
ZP
0 ... 10 V
AGND
Fig. 29: Connection example
Device specifications
I/O modules > Analog I/O modules
2022/01/313ADR010278, 3, en_US440