ABB AC500 V3 - Technical data of the digital transistor outputs

Parameter PM5012-T-ETH PM5012-R-ETH PM5032-T-ETH
PM5052-T-ETH
PM5072-
T-2ETH
PM5032-R-
ETH
PM5052-R-
ETH
Fast input
max. 5 kHz
- - DI0 ... DI3 DI0 ... DI3
Fast input,
max. 100 kHz
- - DI6 ... DI7
When using the
A/B encoder on
DI04...DI05 and
the Touch/
Reset inputs on
fast inputs
DI6 ... DI7
When using the
A/B encoder on
DI04...DI05 and
the Touch/
Reset inputs on
fast inputs
Technical data of the digital transistor outputs
Table 15: PM5012-T-ETH
Parameter Value
Number of channels per module 4
Distribution of the channels into groups 1 group of 4 channels
Galvanic isolation Yes, per group
Connection of the channels O0 to O3 Terminals 8 to 11
Common power supply voltage Terminals 12 (+24 V DC, signal name UP)
Reference potential for the channels O0 to O7 Terminal 13 (0 V DC, negative pole of the
process voltage, signal name ZP)
Indication of the output signals 1 yellow LED per channel; the LED is on
when the output signal is high (signal 1)
Way of operation Non-latching type
Min. output voltage at signal 1 UP - 0.1 V
Output delay (max. at rated load)
0 to 1 On request
1 to 0 On request
Rated protection fuse (per group) On request
Output current
Rated current per channel (max.) 0.5 A at UP 24 V DC (resistance, general
use and pilot duty)
Rated current per group (max.) 2 A
Rated current (all channels together, max.) 2 A
Max. leakage current with signal 0 On request
Demagnetization when inductive loads are
switched off
Must be performed externally according to
driven load specification
Switching Frequencies
With inductive loads On request
Short-circuit-proof / Overload-proof No
Overload message No
Device specifications
Processor modules > AC500-eCo
2022/01/313ADR010278, 3, en_US38