ABB AC500 V3 - Connection of analog output loads (Current)

Fig. 147: Connection of analog output loads (voltage)
The following measuring ranges can be configured Ä Chapter 1.7.4.1.7 “Parameterization”
on page 749 and Ä Chapter 1.7.4.1.9 “Measuring ranges” on page 761
Voltage -10 V...+10 V Load ±10 mA max. 1 channel used
The function of the LEDs is described under Diagnosis and displays / Displays Ä Chapter
1.7.4.1.8 “Diagnosis and state LEDs” on page 755.
Unused analog outputs can be left open-circuited.
Connection of analog output loads (Current)
The following figure shows the connection of output loads to the analog output AO0. Proceed
with the analog output AO1 in the same way.
Device specifications
Communication interface modules (S500) > Modbus
2022/01/313ADR010278, 3, en_US746