ABB AC500 V3 - Channel parameters for the analog outputs (2 x)

Internal value Operating modes of the analog inputs, individually configurable
19 3-wire Ni1000 -50 °C...+150 °C *)
*) In the operating modes with 3-wire configuration or with differ-
ential inputs, two adjacent analog inputs belong together (e.g. the
channels 0 and 1). In these cases, both channels are configured in
the desired operating mode. The lower address must be the even
address (channel 0). The next higher address must be the odd
address (channel 1). The converted analog value is available at the
higher address (channel 1).
Table 121: Channel monitoring
Internal Value Check Channel
0 (default) Plausib(ility), cut wire, short circuit
3 Not used
Channel parameters for the analog outputs (2x)
Name Value Internal value Internal
value, type
Default EDS Slot /
Index
0
Output 0,
Channel con-
figuration
see
Ä Table 122 “
Channel con-
figuration”
on page 569
see
Ä Table 122 “
Channel con-
figuration”
on page 569
BYTE 0 0x0Y11
Output 0,
Check
channel
see
Ä Table 123 “
Channel mon-
itoring”
on page 569
see
Ä Table 123 “
Channel mon-
itoring”
on page 569
BYTE 0 0x0Y12
Output 0,
Substitute
value
see
Ä Table 124 “
Substitute
value”
on page 569
see
Ä Table 124 “
Substitute
value”
on page 569
WORD 0 0x0Y13
Output 1,
Channel con-
figuration
see
Ä Table 122 “
Channel con-
figuration”
on page 569
see
Ä Table 122 “
Channel con-
figuration”
on page 569
BYTE 0 0x0Y14
Output 1,
Check
channel
see
Ä Table 123 “
Channel mon-
itoring”
on page 569
see
Ä Table 123 “
Channel mon-
itoring”
on page 569
BYTE 0 0x0Y15
Output 1,
Substitute
value
see
Ä Table 124 “
Substitute
value”
on page 569
see
Ä Table 124 “
Substitute
value”
on page 569
WORD 0 0x0Y16
Device specifications
I/O modules > Digital/Analog I/O modules
2022/01/313ADR010278, 3, en_US568