NOTICE!
Risk of damage to the TA5400-SIM input simulator!
Do not remove the terminal block while the TA5400-SIM input simulator is
connected.
Do not apply mechanical forces to the input simulator when it is connected to
the terminal block.
In both cases the input simulator could be damaged.
1. Make sure that the power supply of the processor module is turned off.
CAUTION!
Risk of damaging the PLC modules!
The PLC modules can be damaged by overvoltages and short circuits.
Make sure, that all voltage sources (supply and process voltage) are
switched off before you start working on the system.
Never connect voltages > 24 V DC to the terminal block of the TA5400-
SIM input simulator.
CAUTION!
Risk of damaging the input simulator and/or PLC modules!
The TA5400-SIM input simulator may only be used with AC500-eCo V3
processor modules PM50x2.
Never use the input simulator with other devices.
The input simulator may only be used with screw-type terminal blocks.
The input simulator is only intended for testing and training purposes.
Never use it within productive sytems.
Assembly
Insertion of the
input simulator
System assembly, construction and connection
AC500-eCo > Handling of accessories
2022/01/31 3ADR010278, 3, en_US 967
To Next Page
Loading...
