Front terminal, conductor connection vertically with respect to the printed circuit board.
Parameter Value
Type Front terminal
Degree of protection IP 20
Stripped conductor end 9 mm, min. 8 mm
Fastening torque 0.6 Nm
Needed tool Slotted screwdriver
Dimensions Blade diameter 3.5 mm
Terminal units with product index < C0 e. g. 1SAP 212 200 R0001 B0
Number of cores per terminal Conductor type Cross section
1 Solid 0.08 mm² to 2.5 mm²
1 Flexible 0.08 mm² to 2.5 mm²
1 with wire-end ferrule Flexible 0.25 mm² to 1.5 mm²
2 Solid Not intended
2 Flexible Not intended
2 with TWIN wire end ferrule (length
10 mm) with plastic sleeve
Flexible 2 x 0.25 mm² or 2 x 0.5 mm² or
2 x 0.75 mm², with square cross-
section of the wire-end ferrule also
2 x 1.0 mm²
Terminal units with product index ³ C0 e. g. 1SAP 212 200 R0001 C0
Number of cores per terminal Conductor type Cross section
1 Solid 0.08 mm² to 2.5 mm²
1 Flexible 0.08 mm² to 2.5 mm²
1 with wire-end ferrule without
plastic sleeve
Flexible 0.08 mm² to 2.5 mm²
1 with wire-end ferrule with plastic
sleeve
Flexible 0.14 mm² to 1.5 mm²
2 Solid 0.08 mm² to 1.5 mm²
2 Flexible 0.08 mm² to 1.5 mm²
2 with TWIN wire end ferrule (length
10 mm) with plastic sleeve
Flexible 2 x 0.5 mm² to 2 x 1.0 mm²
2 with separate wire-end ferrule
without plastic sleeve
Flexible 0.08 mm² to 0.75 mm²
Front terminal, conductor connection vertically with respect to the printed circuit board.
Terminal type:
Screw-type ter-
minal
Terminal type:
Spring terminal
System assembly, construction and connection
AC500 (Standard) > Connection and wiring
2022/01/31 3ADR010278, 3, en_US 991
To Next Page
Loading...
