276
barcode input data from into OFF.
•Bit 7 : When this bit is ON, it switches completion bit signal(Bit4 of system signal 2) of numeral input
into OF F.
※ Refer to barcode part for the details about Bit 4, Bit 5.
31.2.2 Current recipe number
Configure recipe number to read and write among several files of recipe. Write recipe in recipe,
configure recipe number in this device and give a read/write trigger signal, each operation is
occurred.
+1 of designated word device address is allotted in system information of editor.
※ Refer to recipe for the details.
31.2.3 System signal 3
•Bit 0 : Buzzer control. Buzzer is ON when it is ON status, buzzer is OFF when it is OFF status.
•Bit 4 : Backlight control.
Backlight is OFF when it is ON status, backlight is ON when it is OFF status.
•Bit 5 : Print control. It starts to print alarm when it is changed as OFF->ON.
31.2.4 Reserved area (12 points)
31.3 WRITE DEVICE
It monitors GP status reading GP device in PLC.
31.3.1 Current base screen number (Write device)
It writes current screen number of GP.
When user switches screen, this device value is changed into number of switched screen.
31.3.2 Current overlap screen number 1(Write device+1)
It registers screen number of overlap screen 1 of GP in PLC device configured in system
information. +1 of designated word device address is allotted in system information of editor.
31.3.3 Current overlap screen number 2(Write device +2)
It registers screen number of overlap screen 2 of GP in PLC device configured in system
information.
31.3.4 Input tag ID(Write device+3)
It saves user ID of input tag in this device if there is a screen configured numeral input or ASCII
input.
To Next Page
Loading...
Need help?
General