Configuring SNTP Settings
D-Link Unified Wired and Wireless Access System
Oct. 2015 Page 100
D-Link UWS User Manual
• To add an SNTP server, select Create from the Server list, complete the remaining fields as desired, and
click Submit. The SNTP server is added, and is now reflected in the Server list. You must perform a save to
retain your changes over a power cycle.
• To removing an SNTP server, select the IP address of the server to remove from the Server list, and then
click Delete. The entry is removed, and the device is updated.
SNTP Server Status
The SNTP Server Status page displays status information about the SNTP servers configured on your switch.
To access the SNTP Server Status page, click LAN > Monitoring > SNTP Summary > Server Status in the
navigation menu.
Figure 32: SNTP Server Status
Table 27: SNTP Server Status Fields
Field Description
Address Specifies all the existing Server Addresses. If no Server configuration exists, a
message saying “No SNTP server exists” flashes on the screen.
Last Update Time Specifies the local date and time (UTC) that the response from this server was
used to update the system clock.
Last Attempt Time Specifies the local date and time (UTC) that this SNTP server was last queried.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
