D-Link DWL-2600AP

Booting the Switch
D-Link Unified Wired and Wireless Access System
Oct. 2015 Page 50
D-Link UWS User Manual
Start Operational Code
Use option 1 to resume loading the operational code.
To relaunch the boot process from the Boot menu:
1. On the Boot menu, select 1 and press <Enter>.
The following prompt displays:
Operational Code Date: Thu Jun 8 12:51:44 2006
Uncompressing.....
50% 100%
||||||||||||||||||||||||||||||||||||||||||||||||||
1 File: bootos.c Line: 462 Task: ffffe00 EC: 2863311530 (0xaaaaaaaa)
(0 d 0 hrs 0 min 13 sec)
Timebase: 24.750275 MHz, MEM: 99.001100 MHz, PCI: 33.000366 MHz, CPU: 198.002200 MHz
PCI device BCM5675_A0 attached as unit 0.
PCI device BCM5695_B0 attached as unit 1.
PCI device BCM5695_B0 attached as unit 2.
PCI device BCM5673_A1 attached as unit 3.
PCI device BCM5673_A1 attached as unit 4.
Adding BCM transport pointers
Configuring CPUTRANS TX
Configuring CPUTRANS RX
st_state(0) = 0x0
st_state(1) = 0x3
st_state(2) = 0x2
Change Baud Rate
Use option 2 to change the baud rate of the serial interface.
To change the baud rate from the Boot menu:
1. On the Boot menu, select 2 and press <Enter>.
The following prompt displays:
[Boot Menu]2
Select baud rate:
1 - 1200
2 - 2400
3 - 4800
4 - 9600
5 - 19200
6 - 38400
7 - 57600
8 - 115200
0 - no change
2. The bootup process resumes.
Note: The selected baud rate takes effect immediately.