AP Management
D-Link Unified Wired and Wireless Access System
Oct. 2015 Page 590
D-Link UWS User Manual
AP Provisioning
The AP Provisioning feature helps you add new APs to an existing switch cluster. With AP Provisioning, you can
configure the access points with parameters that are needed to connect to the wireless network.
Use AP Provisioning to connect devices to a network enabled for mutual authentication. If a network is not
enabled for mutual authentication then APs can be attached to the network by properly configuring the local
Valid AP database or RADIUS AP database and discovery options. The provisioning feature can optionally be
used on networks not enabled for mutual authentication to simplify AP attachment to the cluster.
AP Provisioning Summary Status
Use the AP Provisioning Summary Status page to view information about all provisioned APs.
Figure 377: AP Provisioning Summary Status
The following table shows the fields available on the AP Provisioning Summary Status page.
Note: The AP Provisioning Summary and Detail pages display data only when the switch is configured
as the Cluster Controller.
Table 346: AP Provisioning Summary Status
Field Description
MAC Address MAC address of the AP
IP Address IP Address of the AP.
Primary IP Address The IP address of the primary provisioned switch as reported by the
AP.
Backup IP Address The IP address of the backup provisioned switch as reported by the AP.
New Primary IP Address Enter the IP address of primary switch to which the AP should try to
connect.
New Backup IP Address Enter the IP address of switch to which the AP should try to connect if
it is unable to connect to the primary switch.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
