Configuring Advanced Settings
D-Link Unified Wired and Wireless Access System
Oct. 2015 Page 597
D-Link UWS User Manual
Command Buttons
The page includes the following buttons:
• Submit—Updates the switch with the values you enter. To retain the new values across a power cycle,
you must perform a save (Tool > Save Changes).
• Refresh—Updates the page with the latest information.
Wireless SNMP Trap Configuration
If you use Simple Network Management Protocol (SNMP) to manage the DWS-4000 Series switch, you can
configure the SNMP agent on the switch to send traps to the SNMP manager on your network from the
Administration > Advanced Configuration > Global > SNMP Traps tab.
Figure 380: SNMP Trap Configuration
When an AP is managed by a switch, it does not send out any traps. The switch generates all SNMP traps based
on its own events and the events it learns about through updates from the APs it manages.
All Wireless SNMP traps are disabled by default.
Table 349 describes the events that generate SNMP traps. All
traps are disabled by default.
Note: You can configure the Wireless traps only if the Wireless Trap Mode is enabled, which you
configure on the LAN > Administration > SNMP Manager > Trap Flags page.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
