Configuring a Network to Use WPA2-Enterprise and Dynamic
VLANs
D-Link Unified Wired and Wireless Access System
July 2012 Page 713
D-Link UWS User Manual
Verifying the Configuration
This section describes the pages available for monitoring information the managed AP and its associated
clients.
1. Verify that the AP is now managed by the switch.
Click WLAN > Monitoring > Access Point > Managed AP Status and verify that the AP_1 status is Managed
and the Configuration status is Success.
2. Verify that the engineer user can connect to the Corporate network and is assigned to VLAN 20.
a. Use a wireless client to access the wireless network with the Corporate SSID.
b. When prompted for the username and password, enter engineer for both fields.
c. To verify the VLAN assigned to the engineer user, go to the WLAN > Monitoring > Client > Associated
Clients page and select the MAC address of the client Note the VLAN of the engineer user is VLAN 20,
the default VLAN for the VAP.
To Next Page
Loading...
