D-Link DWL-2600AP User Manual

Save All Applied Changes
D-Link Unified Wired and Wireless Access System
Oct. 2015 Page 171
D-Link UWS User Manual
Save All Applied Changes
When you click Submit, the changes are applied to the system and saved in the running configuration file.
However, these changes are not saved to non-volatile memory and will be lost if the system resets. Use the
Save All Applied Changes page to make the changes you submit persist across a system reset.
To access the Save All Applied Changes page, click Tool > Save Changes in the navigation tree.
Figure 85: Save All Applied Changes
Click Save to save all changes applied to the system to NVRAM so that they are retained if the system reboots.
Download File To Switch (TFTP)
Use the Download File to Switch page to download the image file, the configuration files, CLI banner file, and
SSH or SSL files from a TFTP server to the switch.
You can also download files via HTTP. See “HTTP File Download” on page 174 for more information.
To access the Download File to Switch page, click Tool > Download File in the navigation tree.
Figure 86: Download File to Switch

D-Link DWL-2600AP Specifications

General

Networking standards	IEEE 802.3af
Ethernet LAN data rates	10, 100 Mbit/s
Maximum data transfer rate	300 Mbit/s
Internal	Yes
LED indicators	Power, Stand-by, Status, WAN, WLAN
WAN connection	Ethernet (RJ-45)
Ethernet LAN (RJ-45) ports	1
Security algorithms	WEP, WPA, WPA2
Operating temperature (T-T)	0 - 40 °C
Operating relative humidity (H-H)	10 - 90 %

Weight and Dimensions

Width	160 mm
Height	45 mm
Weight	240 g
Dimensions (WxDxH)	160 x 160 x 45 mm