Basic Setup
D-Link Unified Wired and Wireless Access System
Oct. 2015 Page 569
D-Link UWS User Manual
Valid Access Point Summary
The Wireless Global Configuration page contains a field to select whether to use a local or RADIUS database
for AP Validation. The Valid Access Point Summary page contains information about APs configured in the
local database. If the AP Validation is set to RADIUS, information about the APs to be managed by the switch
must be added to the external RADIUS database.
You can add an AP into the local list of Valid APs from the WLAN > Administration > Basic Setup > Valid AP
tab, as the following figure shows, or you can add an AP from the AP Authentication Failures or Rogue AP/RF
Scan lists.
Figure 365: Adding a Valid AP
Table 333: Valid Access Point Summary
Field Description
AP Database Identifies the total number of APs that have been added to the AP database.
Managed AP Identifies the number of APs in the database with an AP Mode set to Managed.
Rogue AP Identifies the number of APs in the database with an AP Mode set to Rogue.
Standalone AP Identifies the number of APs in the database with an AP Mode set to Standalone.
MAC Address Enter the MAC address of the AP in this field. When you add the MAC address, you
add the AP to the local database on the switch.
Location Enter a location to help identify the AP. This field is optional and accepts up to 32
alphanumeric characters, including special characters.
AP Mode This field displays the current mode of the AP, which can be one of the following:
• Managed
• Standalone
• Rogue
To configure a different mode, click the MAC address of the AP to go to the Valid
Access Point Configuration page.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
