Basic Setup
D-Link Unified Wired and Wireless Access System
Oct. 2015 Page 570
D-Link UWS User Manual
After you enter the MAC address and location of the AP to add to the list, click Add to add the AP to the
database and to access the configuration page for the AP. For an AP that is already in the database, click the
MAC address of the AP to access its configuration page.
Command Buttons
The page includes the following buttons:
• The Delete button clears an entry from the current list.
• The Delete All button clears all entries from the list.
• The Refresh button refreshes the list of APs.
• The Change Profile button changes the profile assigned to the selected AP or APs.
Valid Access Point Configuration
From the Valid AP Configuration page, you can manually set the channel and RF signal transmit power level
for an individual AP. You can also configure the AP mode and local authentication password, and you can
specify which profile the AP uses.
If you use the local database for AP validation, the switch maintains the database of access points that you
validate. When you add the MAC address of an AP to the database, you can specify whether the AP is a
managed AP, standalone AP, or a rogue. If the AP is to be managed by the switch, you can assign an AP profile
to the device. When the switch collects and reports information from the RF scan, it can assign the appropriate
status to an AP if it is in the database.
Profile This field displays the AP profile assigned to the AP.
To assign a different profile to the AP, click the MAC address of the AP to go to the
Valid Access Point Configuration page. Click the profile name to access the
configuration pages for the profile.
Note: Any configuration changes for a managed AP will not be applied until the AP is reset and re-
authenticated. If you select a different profile from the menu, a pop-up message asks you to confirm
the change. If the AP is managed, a second message asks if you would like to reset the AP. If you click
OK, the AP is reset.
Table 333: Valid Access Point Summary
Field Description
To Next Page
Loading...
Need help?
General
Weight and Dimensions
