Telnet Sessions
D-Link Unified Wired and Wireless Access System
Oct. 2015 Page 93
D-Link UWS User Manual
• If you change any of the telnet parameters, click Submit to apply the changes to the system. If you want
the switch to retain the new values across a power cycle, you must perform a save.
Table 21: Telnet Session Configuration Fields
Field Description
Telnet Session Timeout
(minutes)
Specify how many minutes of inactivity should occur on a telnet session
before the session is logged off. You may enter any number from 1 to 160. The
factory default is 5.
Note: When you change the timeout value, the new value is applied to all
active and inactive sessions immediately. Any sessions that have been idle
longer than the new timeout value are disconnected immediately.
Maximum Number of Telnet
Sessions
From the drop-down menu, select how many simultaneous telnet sessions to
allow. The maximum is 5, which is also the factory default. A value of 0
indicates that no outbound Telnet session can be established.
Allow New Telnet Sessions Controls whether to allow new telnet sessions:
• Yes: Permits new telnet sessions until the maximum number allowed is
reached.
• No: New telnet sessions will not be allowed, but existing sessions are not
disconnected.
Telnet Server Admin Mode Administrative mode for inbound telnet sessions. Setting this value to disable
shuts down the telnet port. If the admin mode is set to disable, then all
existing telnet connections are disconnected. The default value is Enable.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
