Understanding the User Interfaces
D-Link Unified Wired and Wireless Access System
Oct. 2015 Page 56
D-Link UWS User Manual
Understanding the User Interfaces
D-Link DWS-4000 Series software includes a set of comprehensive management functions for configuring and
monitoring the system by using one of the following three methods:
• Web User Interface
• Command-Line Interface (CLI)
• Simple Network Management Protocol (SNMP)
Each of the standards-based management methods allows you to configure and monitor the components of
the D-Link DWS-4000 Series software. The method you use to manage the system depends on your network
size and requirements, and on your preference.
This guide describes how to use the Web-based interface to manage and monitor the system. For information
about how to manage and monitor the system by using the CLI, see the D-Link DWS-4000 Series CLI Command
Reference.
Using the Web Interface
To access the switch by using a Web browser, the browser must meet the following software requirements:
• HTML version 4.0, or later
• HTTP version 1.1, or later
• JavaScript™ version 1.5, or later
Use the following procedures to log on to the Web Interface:
1. Open a Web browser and enter the IP address of the switch in the Web browser address field.
2. Type the user name and password into the fields on the login screen, and then click Login.
The user name and password are the same as those you use to log on to the command-line interface. By
default, the user name is admin, and there is no password. Passwords are case sensitive.
Note: The switch web UI supports Internet Explorer v6 and v7. Appropriate display of the web pages
is not guaranteed for other web browsers.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
